This is 100W inverter circuit. It uses 4047 IC and IRF540 Mosfet instead of 2N3055 transistor. Power output is 100W from 2-3A transformer.
Popular Posts
-
Superheterodyne receivers have been mass-produced since around 1924, but for reasons of cost did not become successful until the 1930s. ... -
This project was a particular surprise for me in that the BC547 (equiv 2N2222) can be used to build a 500mW linear amplifier covering the en... -
We have already seen in many of my earlier articles how triacs are used in electronic circuits for switching AC loads. Triacs are basically ... -
Inductors can be mimicked quite easily using operational amplifiers. The circuit shown here was developed to have an inductance of 1000 H (s... -
Voltage regulator ICs (78xx series) provide a steady output voltage, as against a widely fluctuating input supply, when the common term... -
If you are lucky enough to have a big house, a large garden, and small children, this project just might interest you. It’s actually a telep... -
Israeli-born Parisian designer Arik Levy has recently demonstrated the well of life, he designed a series of lighting products Fontana,. The...
-
This circuit came about as the result of an urgent need for a NiMH battery charger. No suitable dedicated IC being immediately to hand, t... -
Before its move offshore, I was lucky enough to be involved in developing the avionics system for the Flightship Ground Effect FS8 craft (se... -
A filter removes the dc component of the rectified ac, which is then scaled to RMS. The output is linear from 40 Hz to 10 kHz or higher. Cu...
